The operator functions:
Load the material (inks – cliché – tape – carton cores)
Set up and monitor the printing stations and feeding ink when needed
Set up the slitting station
At the end of the desired printing length cut the material, discharge the printed rolls and load the empty cores on which will be attached the material to continue printing operation
380 Volts – 50 Hz – 3-Phase (other voltages on request)
Cast Iron Support Frame
Safety Guards all over the machine except the rewinding shafts.
When safety doors are opened the L33 stops and it can run pushing Start bottom at impulses.
No-noise panels all around the machine.
Air-expanding 3” i.d. frictioned un-winder for PP tape
Noise reducer/Low Tape alarm pressure roller
Magic eyes for tape breakage alarm
4 Printing Stations complete with metal screened rollers and printing cylinders with gears for 150,7 mm print repeat
45° gearing to allow printing adjustment while the machine is working
Adjustable bracers for each printing station
Thermo-adjustable Teflon covered central drum
Individual adjustable Suction air fan for each printing stat.
Laminating – Die Cutting – Waste Rewinding Systems
Leister for fast drying
Laminating Device with 3” i.d. frictioned un-winder
Double die cutting station either from the top or the bottom
Motorized waste re-winder for 3” i.d. core
Horizontal Ventilation/Suction tunnel for colours drying
Vertical Ventilation/Suction tunnels for colour drying
Slitting station with razor blades from the adhesive side
Twin turrets re-winders with 2 mandrels for 3” i.d. cores each rotating at the pre-selected tape roll length
All you need to run your factory !
