Round column drills Geared transmission B-50

IBARMIA mod. B-50       Drill with sliding table   Transmission by gears   9 spindle speeds   6 automatic feeds   Electromagnetic clutch   Deph scale and adjustable depth stop   Built-in low voltage electrical equipment in machine head   Gear box lubrication by automatic pump   Automatic tool ejector   Speed plate and selecting levers on head front   Emergency STOP push button   Coolant system and worklight   Tiltable   Right/left turn   Front hand wheel for fine feed work   Drill guard with microswitch*   CEE Norms   Colour combination of RAL7004 and RAL7466       Technical characteristics:   Maximum drilling capacity in steel St.60 50 mm. Maximum drilling capacity in cast iron 200 Brinell 60 mm. Maximum tapping capacity in steel St.60 M 36. Maximum tapping capacity in cast iron 200 Brinell M 42. Morse Taper MT MT-4. Maximum spindle stroke (drilling depth) 230 mm. Main motor power 4CV. Coolant pump motor power 0,10CV. Transmission Gear box. Number of speeds 9. Speed range with motor at, 1500 r.p.m. 50 Hz 54-1032 rpm. Feed Automatic by electromagnetic clutch Number of automatic feeds 6. Automatic feed range 0,1-0,2-0,3-0,4-0,5-0,6. Worktable dimensions (LxW) 550x550 mm. Column diameter 200 mm. Distance from spindle centre to column face 400 mm. Net weight 720 Kg. Gross weight with packing 805 Kg. Packing dimensions (length x width x height) 2,60x0,68x1,21 m.     Optional equipment:   RS: Automatic feed reversing for tapping   RPF: Pitch controlled tapping with braking system   RPF+TAK: RPF with digital rpm counter   HGP: Master guide spindle and nut set   HGP-S: Master guide spindle and nut set with special thread (inches, etc)   ACNL: Pneumatic counterbalance with rapid approach and retract   CI: Integral driling cycle with encoder.   CI-RPF:Integral drilling cycle with encoder and pitch controlled tapping with braking system by speed inverter.   AR: 50% lowere feed rate range   CN: Penumatich counterbalance   UC: Union, dragging cone and assembly for multi-spindle head   GM: Multi-spindle head guide rod   CM: Auxiliary commanding box (start-stop and emergency stop)   SC: Column riser (200 mm)   VE: Variable speed by electronic variator   VE+TAK: Continuos speeds by electronic variator and digital rpm counter   LBC: Digital read-out scale   MB: Security Bimanual command   FL-157: 157 mm opening fixed vice   FL-116: 116 mm opening fixed vice   P16-M4: Drill chuck from Ø1 to Ø16 mm Morse 3 taper